If you instead click the “Delete” button at the bottom of this screen, Be sure to check the “Delete” checkbox associated with the alias. To delete an alias, highlight the interface in the tree to access Set multiple aliases, click the “Add extra alias” link for each alias you wish to configure. This screen also allows you to configure an IP alias for the interface, which allows the interface to be configured with multiple IP addresses. Separate multiple parameters with a space for example: mtu 9000 will increase the MTU for interfaces that Only one interface can be configured for this option requires manual configuration if unchecked and wish to use Requires static IPv4 or IPv6 configuration if unchecked note that only one interface can be configured for DHCP Select the FreeBSD device name will be a read-only field when editing an interface Table 7.2a: Interface Configuration Settings Setting Click “Yes” to proceed with the network restart or “No” to cancel the operation.įigure 7.2a: Adding or Editing an Interface Note that if any changes to this screen require a network restart, the screen will turn red when youĬlick the “OK” button and a pop-up message will remind you that network connectivity to the FreeNAS® system will be interrupted while the changes areĪpplied. Table 7.2a summarizes the configuration options when youĪdd an interface or edit an already configured interface. Though it is already dynamically configured and in use.įigure 7.2a shows the screen that opens when you click Interfaces ‣ Add Interface. This interface will not appear in this screen, even Typically the interface used to access the FreeNAS® administrative GUI is configured by DHCP. The FreeNAS® system in the “Host name database” field. If your network does not have a DNS server or NFS, SSH, or FTP users are receiving “reverse DNS” or timeout errors, add an entry for the IP address of If you will be using Active Directory, set the IP address of the realm’s DNS server in the “Nameserver 1” field. IP_address space hostname where multiple hostnames can be used if separated by a space Used to add one entry per line which will be appended to /etc/hosts use the format If “Enable netwait feature” is checked, list of IP addresses to ping otherwise, ping the default gateway If enabled, network services will not be started at boot time until the interface is able to ping the addresses Primary DNS server (typically in Windows domain)Įnter the proxy information for the network in the format netwait feature Table 7.1a: Global Configuration Settings Setting The hostname and domain will be pre-filled for you, as seen inįigure 7.1a, but can be changed to meet the local network’s requirements. Table 7.1a summarizes the settings that can be configured using the Global Configuration tab. I would advise that if this is having any knock on impacts to a production environment however that you engage with Commvault Support in order to have this looked into at a more in depth level.Network ‣ Global Configuration, shown in Figure 7.1a, allows you to set non-interface specific network settings. If you find any SVMs reporting associations with the wrong array then this issue can be addressed by entering the Netapp client properties and correcting the association. The following commands should be able to help identify if SVMs are in use across incorrect/multiple arrays when ran on both filers (from the cluster level): Hi confirm is this a new configuration or has this previously been operational and you’re suddenly having issues?Ī few things to check off are the following:Ĭommvault version dependant please double check the configuration meets the requirements Īnother thing to be made aware of if this array has been added to an environment with existing arrays configured is that previously we’ve seen an issue where SVMs have become associated with two arrays following the configuration of a new array within the environment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |